BIOGAS COMPRESSORS

UVG160/BVG75

LOCATION: ITALY
FLUID: Biogas

UVG 160
POWER INSTALLED: 150 hp (x3)
INLET PRESSURE: 5,8 psi(g)
WORKING PRESSURE: Up to 178,4 bar(g)
FLOW RATE: 0<336<673 SCFM
AMBIENT TEMPERATURE: +14/+104 °F

BVG 75
POWER INSTALLED: 100 hp (x2)
INLET PRESSURE: 7,3 psi(g)
WORKING PRESSURE: Up to 58 psi(g)
FLOW RATE: 0<238<475 SCFM
AMBIENT TEMPERATURE: +14/+104 °F

Five screw compressors for biogas upgrading located in Italy. Three of them provides the biogas to the upgrading system, instead two of them recirculates the remaining methane and carbon dioxide to achieve greater efficiency for its recovery through the upgrade system. All compressors are designed for classificated Atex Zone 2, completed with fine filtration and temperature control.

ABOUT BVG/UVG SERIES

[contact_form]

OTHER REFERENCES

UVG 22

France

Screw compressor for CO₂ located in France. Designed for non-hazardous area for outdoor installation. It is air cooled and completed with fine filtration, electrical cabinet in the compressor skid, fully electrical by-pass system and controlled by PLC. The compressor is equipped with silencers (maximum noise level: 74 dB(A) at 1 meter).

UVG 160

USA

Screw biogas compressor for upgrading located in USA. Designed in compliance with ASME and UL standards (Class 1 Division 2) for outdoor installation. It is air cooled and completed with fine filtration, temperature control, electro-pneumatic bypass valve and controlled by PLC.

ADI115-22

Czech Republic

Single stage reciprocating compressor for biomethane installed in Czech Republic. Designed for classified Atex Zone 2 for outdoor installation. It is air cooled and completed with electro-pneumatic by-pass system, fine filtration and controlled by PLC.

ADI115-30

Netherlands

Double stage reciprocating compressor installed in the Netherlands. Designed for classified Atex Zone 2 for outdoor installation. It is water cooled and completed with bleed valve for depressurization to vent, electro-pneumatic proportional bypass valve and controlled by PLC.

UVG 650

Denmark

Two screw compressors for biogas upgrading installed in Denmark. Each compressor is installed inside a dedicated 40' container. They are designed for classified ATEX Zone 2 for outdoor installation. The compressors are water-cooled and completed with heat recovery, temperature control, electropneumatic by-pass valve, and are controlled by PLC.

UVG 18.5

Germany

Screw biogas compressor for upgrading located in Germany. Designed for classified Atex Zone 2 for outdoor installation. It is air cooled and completed with fine filtration, mechanical bypass valve and controlled by HMI.

VG 55

Germany

Screw compressor for natural gas located in Germany. Designed for classified Atex Zone 2 for outdoor installation. It is air cooled and completed with fine filtration, electromechanical by-pass system and controlled by PLC.

UVG 355

Italy

Screw compressor for biogas upgrading located in Italy. Designed for outdoor installation. It is water cooled and completed with temperature control, fully electrical by-pass system, fine filtration and controlled by PLC. It is equipped with silencers for reducing the noise level to 75 dB@ 10m.